SMA SC 500CP-10-JP Installation Manual - Manual (Page 39)

SMA Solar Technology AG 8 Installing the Sunny Central
Installation Manual SCCP-JP-IA-A4-en-12 39
Mounting the Lid of the Silencing Baffle
Required mounting material:
☐ 1 cylinder head screw
☐ 3 contact washers
☐ 9 pan head flange screws
☐ 13 washers
☐ 10 hexagon nuts
Procedure:
1. Align the lid at the rear panel. Push the lid over the stud bolt.
2. Screw the cylinder head screw with contact washer into the upper
left thread. Do not yet tighten the screw.
3. Screw five pan head flange screws into the upper threads of the
lid. Do not yet tighten the screws.
4. Screw the ventilation plate of the rear panel of the silencing baffle
to the lid. Do not yet tighten the four pan head flange screws.
5. Screw two hexagon nuts with contact washers to the right-hand
and left-hand lower stud bolts of the rear panel.