Install the kick plates of the disconnect unit – SMA DU-SC-US User Manual
Page 24
Advertising
Transporting the Disconnect Unit Without Packaging
SMA America, LLC
24
DISU_SCUS-AP-eng-IUS110911
Unpacking
Install the Kick Plates of the Disconnect Unit
After transporting the Disconnect Unit, replace the kick plates.
1. Align both front kick plates to the Disconnect Unit and
place all eight screws in the holes.
2. Tighten all eight screws of the two front kick plates
with a torque of 44 in-lbs. (5 Nm).
3. Align both rear kick plates to the Disconnect Unit and
place all eight screws in the holes.
4. Tighten all eight screws of the two rear kick plates
with a torque of 44 in-lbs. (5 Nm).
Advertising