Yaskawa GPD515-XXXX-CS004 - Manual (Page 2)

Added Parameters:
This software does not add any new parameters to the drive.
Changed Parameters:
Refer to Appendix 1 ot the GPD 515 Technical Manual, TM 4515. The following changes result from
the installation of this software in the drive.
Parameter Function Name Changed Standard 1000 Hz
Software Software
A1-02 Control Method Selection Max. Value 3 0
Factory Setting 2 0
b3-03 Speed Search Deceleration Min. Value 0.0 1.0
Time
b6-01 Dwell Frequency at Start Max. Value 400.0 1000.0
b6-03 Dwell Frequency at Stop Max. Value 400.0 1000.0
b8-02 Energy Saving Frequency Max. Value 400.0 1000.0
C6-01 Carrier Frequency Upper Limit Max. Value 15.0 (1) 10.0 (1)
C6-02 Carrier Frequency Lower Limit Max. Value 15.0 (1) 10.0 (1)
d1-01 thru Frequency References Max. Value 400.0 1000.0
d1-08 Increment 0.01 0.1
d1-09 Jog Frequency Reference Max. Value 400.0 1000.0
Increment 0.01 0.1
Factory Setting 6.00 60.0
d2-02 Reference Lower Limit Max. Value 100.0 109.0
d3-01 thru Critical Frequency Rejection Max. Value 400.0 1000.0
d3-03
E1-04 Max Frequency Max. Value 400.0 1000.0
E1-06 Base Frequency Max. Value 400.0 1000.0
E1-07 Mid Frequency A Max. Value 400.0 1000.0
E1-09 Min Frequency Max. Value 400.0 1000.0
E1-11 Mid Frequency B Max. Value 400.0 1000.0
H1-01 thru Multi-Function Input Terminal Max. Value 77 66
H1-06 Selection
L2-04 Power Loss V/F Ramp Time Max. Value 2.0 5.0
L4-01 Speed Coincidence Level Max. Value 400.0 1000.0
L4-03 Speed Coincidence Level + – Max. Value 400.0 1000
Min. Value –400.0 –1000
Increment 0.1 1
(1) Setting will differ depending on drive capacity
Doc. No. 02Y00025-0420 Page 2 of 4 This Page: | Change | 0 | 4/18/97 |