Yaskawa SmartTrac PCIM Card - Manual (Page 21)

SMART TRAC Genius PCIM Card
Technical Manual 3554-0080 Testing Card Installation
••
17
Testing Card Installation
Testing the Network
Once installed, check the on-board indicator lights. Normally, both LEDs should
be illuminated.
On-board Indicator Lights
Two LED indicator lights on the Smart Trac Genius PCIM card provide system-
related information:
•
GENI 104 Self-test/Health LED: When ON, indicates that power is
available to the card and the card self-test was successful. When OFF,
indicates a card failure, improper address assignment, or that the /RST
input line is low.
•
Communications LED: When ON, indicates that power is available to
the card and the controller's communications hardware is functional
and can send data (receives the token) every serial bus scan. When
OFF, indicates that an error has been detected in the communications
hardware or while accessing the Genius serial bus.
LED 2 - Communications
LED 1 - GEN 104 OK
PC/104 Connector
Figure 5. Genius Card Connectors and LEDs