Lanner FW-7582 - Manual (Page 14)

10
Motherboard Information
Chapter 2
Network Application Platforms
Jumper Settings
VGA Interface (VGAA1): An 2x6 (2.0mm) header for
connecting the VGA interface cable. The VGA is provided
by Intel® Graphic Media Accelerator 3150:
USB Connector (USBA1/USBA2) : An 2x5 pin header for
connecting the USB module cable. It complies with USB2.0
and support up to 480 Mbps connection speed.
AT Mode Power Button Connector (J18): It is for
connecting power switch in AT mode. Note that you will
need to adjust the AT/ATX mode selection jumper J21.
AT/ATX Mode Selection Jumper(J21): This jumper is used
for switching power mode between AT and ATX. Please
adjust them accordingly as described in the following
jumper settings.
4 Pin TACT Power Button for debug purpose (SW1):
2-pin System Power Switch (CONN2): This connector is
for connecting power switch in ATX mode .
CompactFlash Connector (CF1): It is for connecting a
Compact Flash card to be served as your system’s storage.
PIN DESCRIPTION PIN DESCRIPTION
1 GND 26 CF_DIS_N
2 DATA3 27 DATA11
3 DATA4 28 DATA12
4 DATA5 29 DATA13
5 DATA6 30 DATA14
6 DATA7 31 DATA15
7 -CF_DCS0 32 -CF_DCS1
8 GND 33 CF_VS1
9 GND 34 IOR#
10 GND 35 IOW#
11 GND 36 +3.3V
12 GND 37 CF_IDEIRQ
13 +3.3V 38 +3.3V
14 GND 39 MST_SLV
15 GND 40 CF_VS2
16 GND 41 CF_IDERST_N
17 GND 42 CF_IORDY
18 A2 43 CF_DMARQ
19 A1 44 CF_DDACK_N
20 A0 45 CFACT_N
21 DATA0 46 CF_PDIAG
22 DATA1 47 DATA8
23 DATA2 48 DATA9
24 NC 49 DATA10
25 CF_DIS_N 50 GND
1 1
9
7
5
3
1
12
10
8
6
4
2
25 1
50 26
CF1
Pin No. Pin Name Pin No. Pin Name
1 Red 2 GND
3 Green 4 GND
5 Blue 6 GND
7 HSYNC 8 NC
9 VSYNC 10 GND
11 Detect-display Data 12 Deteck-display CLOCK
Pin No. Pin Name Pin No. Pin Name
1 VCC 2 VCC
3 USBD- 4 USBD-
5 USBD+ 6 USBD+
7 GND 8 GND
9 GND 10 GND
Pin No. Function
-- ATX mode (Default)
1-2 AT mode
1 2
Pin No. Function
1 PSON#
2 Ground
1 2
Pin No. Pin name
1 PWR_BTN_N
2 GND 2 1
1 3 5 7 9
2 4 6 8 10
USBA2
1
3
5
7
9 2
4
6
8
10
USBA1
1
3
2
4
Pin No. Function
1 Ground
2 Ground
3 PWR_BTN_N
4 PWR_BTN_N