Lanner FW-7582 - Manual (Page 9)

5
Introduction
Chapter 2
Network Application Platforms
Chapter 2:
Hardware Setup
Preparing the Hardware Installation
To access some components and perform certain service
procedures, you must perform the following procedures
first.
WARNING: To reduce the risk of personal injury,
electric shock, or damage to the equipment,
remove the power cord to remove power from the
server. The front panel Power On/Standby button
does not completely shut off system power.
Portions of the power supply and some internal
circuitry remain active until AC power is removed.
Unpower the FW-7582 and remove the power cord. 1.
Unscrew the 3 threaded screws from the top cover of 2.
the FW-7582 System.
Slide the cover backwards and open the cover
3.
upwards.
Installing the System Memory
The motherboard supports DDR3 memory to meet the
higher bandwidth requirements of the latest operating
system and Internet applications. It comes with two
Double Data Rate(DDR3) Dual Inline Memory Modules
(DIMM) sockets.
Open the DIMM slot latches. 1.
Install the DIMM. 2.
Note:
The motherboards can support up to 16 GB 1.
memory capacity in maximum. .
The memory has to meet with the following 2.
standard: DDR3 1066/1333MHz, Non-ECC,
Unbuffered
Installing the Hard Disk
The system can accommodate one Serial-ATA disks. Follow
these steps to install a hard disk into the FW-7582:
Unsrew the 4 screws on the hard disk tray to take out 1.
the hard disk tray from the system.
Place hard disk on the hard disk tray and align the holes
2.
of the hard disk with the mounting holes on the tray.
Secure the hard disk with 4 mounting screws on the
3.
hard disk tray.
Connect the Serial-ATA power and data cables to the
4.
hard disk’s power and data connectors respectively.
Fix the hard disk back to the system with the screws.
5.
Plug the Serial-ATA cable to the Serial-ATA Connector 6.
on the main board.
1
2
1
2 1