Linx Technologies LICAL-ENC-MS001 - Manual (Page 4)

– – – – 2 3 2 3
Ordering Information
Encoder SEND to Decoder Activation Times (ms)
Baud Rate Initial Start-Up After Valid Rx
With RX_PDN
(Worst Case)
2,400 72.62 38.62 600 + 72.62
9,600 22.42 12.42 300 + 22.42
19,200 13.80 7.30 150 + 13.80
28,800 11.00 6.00 150 + 11.00
Timings
Ordering Information
Part Number Description
LICAL-ENC-MS001 MS Encoder
LICAL-DEC-MS001 MS Decoder
MDEV-LICAL-MS MS Master Development System
MS encoders are shipped in reels of 1,600
Absolute Maximum Ratings
Figure 2: Ordering Information
Figure 3: Absolute Maximum Ratings
Absolute Maximum Ratings
Supply Voltage V
CC
−0.3 to +6.5 VDC
Any Input or Output Pin −0.3 to V
CC
+ 0.3 VDC
Max. Current Sourced by Output Pins 25 mA
Max. Current Sunk by Input Pins 25 mA
Max. Current Into V
CC
250 mA
Max. Current Out Of GND 300 mA
Operating Temperature −40 to +85 ºC
Storage Temperature −65 to +150 ºC
Exceeding any of the limits of this section may lead to permanent damage to the device.
Furthermore, extended operation at these maximum ratings may reduce the life of this
device.
Figure 4: Encoder SEND to Decoder Activation Times (ms)
MS Series Enccoder Specifications
Parameter Symbol Min. Typ. Max. Units Notes
Power Supply
Operating Voltage V
CC
2.0 5.5 VDC
Supply Current l
CC
At 2.0V V
CC
240 300 µA 1
At 3.0V V
CC
370 470 µA 1
At 5.0V V
CC
670 780 µA 1
Power Down Current l
PDN
At 2.0V V
CC
0.10 0.80 µA
At 3.0V V
CC
0.10 0.85 µA
At 5.0V V
CC
0.20 0.95 µA
Encoder Section
Input Low V
IL
0.0 0.15 x V
CC
V 2
Input High V
IH
0.8 x V
CC
V
CC
V 3
Output Low V
OL
0.6 V
Output High V
OH
V
CC
– 0.7 V
Input Sink Current 25 mA
Output Drive Current 25 mA
SEND High to DATA_OUT 1.64 ms
Environmental
Operating Temperature
Range
–40 +85 °C
1. Current consumption with no active loads.
2. For 3V supply, (0.15 x 3.0) = 0.45V max.
3. For 3V supply, (0.8 x 3.0) = 2.4V min.
Electrical Specifications
Figure 5: Electrical Specifications
Warning: This product incorporates numerous static-sensitive
components. Always wear an ESD wrist strap and observe proper ESD
handling procedures when working with this device. Failure to observe
this precaution may result in module damage or failure.