Epson EQUITY 386SX/16 PLUS - Manual (Page 163)

3. Place the front panel face down and remove the screws
securing the slot cover to the panel. Lift out the slot
cover, as shown below.
Set the front panel, slot cover, and screws aside.
4. The hard disk drive cable is connected to the main
system board on the left side of the subassembly, as
shown below.
h a r d d i s k /
drive cable
Grasp the connector and pull it straight up to remove it
from the socket. Do not pull only on the cable.
Installing and Removing Disk Drives B - 2 9