Epson EQUITY 386SX/16 PLUS - Manual (Page 220)

Accessing Your Current Pass word
If you have forgotten your current password and cannot use
your computer, follow these steps:
1. Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 5 to disable
the password function by setting jumper J2 to position A.
2. Turn on the computer. You do not see the
Enter
Password
prompt.
3.
When the
Press <Del> to start SETUP
prompt
appears, press Del.
4. Highlight
Run SETUP
and press Enter. You see the
SETUP menu.
Follow the instructions in Chapter 2 to either set a new
password or select
Not Installed
(if you do not want
to set a new password). Be sure to save your SETUP
information when you exit the program.
5. Turn off the computer and follow the instructions under
“Changing the Jumper Settings” in Chapter 5 to enable
the password function by setting jumper J2 to position B.
6. If you do not have a hard disk, insert the Startup diskette
in drive A. Turn on the computer.
If you set a new password, you see the
Enter Password
prompt. Enter the password to access your system. (See
“Using the Password” in Chapter 3.)
D - 6 Troubleshooting