Epson EQUITY 386SX/16 PLUS - Manual (Page 176)

2. Lower the drive into the computer, fitting the tabs
on the mounting plate into the slots on the side of the
subassembly, as shown below. Guide the ribbon cable
underneath the drive as you lower it.
br
hole
tabs in slots
3. Tilt the drive toward the subassembly and align the
retaining screw hole on the mounting plate with the hole
in the bracket. Secure the drive to the bracket with the
retaining screw.
4. To replace the subassembly, see the instructions on page
B-46.
B - 4 2
Installing and Removing Disk Drives