Eiki LC-NB3E - Manual (Page 27)

-27-
Electrical Adjustments
1. Receive the 16-step grey scale computer signal.
2. Set to COMPUTER mode.
3. Enter the service mode.
[R-SIGNAL CENTER ADJUSTMENT]
4. Connect a digital voltmeter to test point “
TP25R1 ” (+)
and chassis ground (-).
5. Select group no. “ 3 ”, item no. “ 0 ” and change data
value to adjust the voltage to be 7.30 ±0.05V.
[G-SIGNAL CENTER ADJUSTMENT]
6. Connect a digital voltmeter to test point “
TP25G1 ” (+)
and chassis ground (-).
7. Select group no. “ 3 ”, item no. “ 1 ” and change data
value to adjust the voltage to be 7.30 ±0.05V.
[B-SIGNAL CENTER ADJUSTMENT]
8. Connect a digital voltmeter to test point “
TP25B1 ” (+)
and chassis ground (-).
9. Select group no. “ 3 ”, item no. “ 2 ” and change data
value to adjust the voltage to be 7.30 ±0.05V.
1. Receive the 16-step grey scale computer signal.
2. Set to COMPUTER mode.
3. Connect an oscilloscope to test point “TP3551” (+)
and chassis ground (-).
4. Enter the service mode, select group no. “ 3 ”, item no.
“ 7 ” and change data value to adjust amplitude “a” to
be 4.8 ±0.1V.
(a)
Signal Center adjustment
NRS adjustment
1. Receive the 16-step grey scale computer signal.
2. Set to COMPUTER mode.
3. Enter the service mode.
[R-BLACK ADJUSTMENT]
4. Connect an oscilloscope to test point “
TP25R1 ” (+)
and chassis ground (-).
5. Select group no. “ 3 ”, item no. “ 3 ” and change data
value to adjust amplitude “a” to be 10.0 ±0.1V.
[R-BLACK ADJUSTMENT-]
6. Connect an oscilloscope to test point “
TP25G1 ” (+)
and chassis ground (-).
7. Select group no. “ 3 ”, item no. “ 4 ” and change data
value to adjust amplitude “a” to be 10.0 ±0.1V.
[R-BLACK ADJUSTMENT-]
8. Connect an oscilloscope to test point “
TP25B1 ” (+)
and chassis ground (-).
9. Select group no. “ 3 ”, item no. “ 5 ” and change data
value to adjust amplitude “a” to be 10.0 ±0.1V.
(a)
black level
black level
Black Level adjustment