Parkside PWS 125 A1 - Manual (Page 60)

57 PWS 125 A1
GB
MT
♦ Place the rough grinding or cutting disc on the
mounting fl ange with the label side towards
the appliance.
♦ Then replace the tensioning nut on the mount-
ing spindle with the raised side facing up.
♦ Press the spindle locking button to lock the
mechanism.
♦ Tighten the tensioning nut using the span-
ner .
NOTE
► If the disc does not turn smoothly or vibrates
after the change, the disc must immediately
be replaced.
♦ For safety’s sake, run at high idle for 60
seconds after every disc change. Be aware of
unusual noises and sparks.
♦ Check whether all the fastening elements are
correctly fi tted.
♦ Make sure that the arrow showing the direction
of rotation (if any) on the cutting or rough grind-
ing discs (including diamond cutting discs) and
the direction of rotation of the appliance (arrow
showing the direction of rotation on the head)
match.
General information about the
supplied grinding tool
■ Grinding tools are very fragile. Extreme care is
required when handling grinding tools.
■ Check grinding tools and brushes for damage
prior to initial use. Do not use damaged, incor-
rectly clamped or incorrecty installed grinding
tools.
■ Follow the safety instructions on the grinding
tools as well as the restrictions on use or safety
instructions.
Storage and handling
■ Grinding tools are to be treated with care and
transported carefully.
■ Grinding tools should be stored in such a way
that they are not exposed to mechanical da-
mage or environmental infl uences (e.g. moisture).
Before using the grinder
■ You should subject grinding tools to a visual
inspection before each use.
■ Do not use grinding tools if they are damaged
or if the expiration date has elapsed.
Using accessories
Cutting/rough grinding discs
You can use the following cutting/rough grinding
discs on this appliance:
Dimensions:
ø 125 x 22.2 mm to
max. 6 mm thick (off set)
Rotational speed: min. 12000 rpm
Circumferential speed: 80 m/sec
Flap buff er discs for metal
Dimensions: ø 125 mm
Rotational speed: min. 12000 rpm
Additional accessories
You can also use the grinding tools below with the
following technical data:
Spindle thread:
M14
Rotational speed: min. 12000 rpm
Support plate for
sanding sheets with
dimensions: ø
115 mm/125 mm
IB_102828_PWS125A1_LB5.indb 57 22.08.14 11:40