Casio PX-5S - Manual (Page 40)

E-38
Reference
Troubleshooting
Problem Cause Action See Page
No sound is produced when I
press a keyboard key. 1. The VOLUME controller is set to
“MIN”.
1. Rotate the VOLUME controller more
towards “MAX”.
) E-6
2. This Digital Piano does not have
built-in speakers. Nothing will
sound if an output device is not
connected.
2. Connect audio equipment, an amplifier,
or headphones.
) E-7
The pitch of the Digital Piano
is off. 1. Digital Piano tuning is incorrect. 1. Adjust Digital Piano tuning, or turn the
Digital Piano off and then back on again.
) Tutorial
2. The Digital Piano’s key setting is
something other than “440.0 Hz”.
2. Change the key setting to “440.0 Hz”, or
turn Digital Piano power off and then
back on again.
3. A non-standard temperament
setting is being used.
3. Change the temperament setting to
“00:Equal”, which is the standard
modern tuning.
4. Octave shift is enabled. 4. Change the octave shift setting to 0.
Tones and/or effects sound
strange. Turning power off
and then back on again does
not eliminate the problem.
Example: Note intensity does
not change even though I
alter key pressure.
The “Auto Resume” feature is
turned on. Turn off “Auto Resume”. Next, turn power
off and then back on again. ) E-27
Chorus, reverb, and/or delay
are not being applied. 1. Lower the system effect send
and/or return level.
1. Change the system effect send and/or
return levels to greater values.
) Tutorial
2. A small value is selected for the
effect setting of an effect
parameter.
2. Select a larger value for the effect
setting of the effect parameter.
I cannot transfer data after
connecting the Digital Piano
to a computer. — 1. Check to make sure that the USB cable
is connected to the Digital Piano and
computer, and that the correct device is
selected with your computer’s music
software.
) E-36
2. Turn off the Digital Piano and then exit
the music software on your computer.
Next, turn the Digital Piano back on and
then restart the music software on your
computer.
I cannot store data to a USB
flash drive or load data from a
USB flash drive. — See “Error Messages”. ) E-35
A tone’s quality and volume
sounds slightly different
depending where it is played
on the keyboard. This is an unavoidable result of the digital sampling process * , and does not indicate
malfunction.
* Multiple digital samples are taken for the low range, middle range, and high range of the
original musical instrument. Because of this, there may be a very slight difference in tonal
quality and volume between sample ranges.
When I press a button, the
note that is sounding cuts out
momentarily or there is a
slight change in how effects
are applied. Performing a button operation while playing with the recorder, or other functions can cause
such phenomena when the Digital Piano switches internal tone effects. It does not indicate
malfunction.
Even though I play on
different ranges of the
keyboard, the notes do not
change octaves. The ranges of certain tones are limited, which means that octaves change normally up to a
certain low note or high note. With such a tone, the notes of the lowest octave will be repeated
to the left of the lowest possible note, and the highest octave will be repeated to the right of
the highest possible note. This is due do limitations in the range of the original musical
instrument for each tone, and does not indicate malfunction of the Digital Piano.
PX5_kihon_e.book 38 ページ ２０１４年３月１７日 月曜日 午後２時２分