Powerplus POWXG6025 LAWNMOWER 190CC 550MM EN - Manual (Page 11)

POWXG6025
EN
Copyright © 2013 VARO P a g e | 11 www.varo.com
8.1 Spark plug (8)
Use only original replacement spark plug. For best results, replace the spark plug every 100
hours of use.
 Stop the engine and remove the spark plug wire.
 Remove spark plug
 Screw the replacement spark plug into the engine and tighten to 25-30 Nm torque and
replace spark plug wire.
 Spark plug gap. 0.6 – 0.7 mm.
CAUTION: Do not over-tighten the spark plug as engine damage may occur.
9 LUBRICATION INSTRUCTIONS
CAUTION: Disconnect spark plug wire before servicing.
 WHEELS-Lubricate the ball bearings in each wheel at least once a season with a light oil.
 BLADE CONTROL-Lubricate the pivot points on the blade control handle and the brake
cable at least once a season with light oil. The blade control must operate freely in both
directions.
10 CLEANING
CAUTION: Do not hose engine. Water can damage engine or contaminate
the fuel system.
 Wipe deck with cloth.
 Hose under deck by tilting the mower so that the spark plug is up.
10.1 Engine air cleaner
CAUTION: Do not allow dirt or dust to clog the air filter foam element.
The engine air cleaner element must be serviced (cleaned) after 25 hours normal mowing.
The foam element must be serviced regularly if the mower is used in dry dusty conditions.
TO CLEAN AIR FILTER: REPLACE IT BY A NEW ONE.
10.2 Cutting blade
CAUTION: Be sure to disconnect and ground the spark plug wire before
working on the cutting blade to prevent accidental engine starting. Protect
hands by using heavy gloves or a rag to grasp the cutting blades.
Tip mower : When the mower is tipped over onto its side, please take care that the air cleaner
is on the top side. Remove the hex bolt and washer which hold the blade and blade adapter
to the engine crankshaft. Remove the blade and adapter from the crankshaft.
WARNING: Periodically inspect the blade adapter for cracks, especially if
you strike a foreign object. Replace when necessary.