Powerplus POWXG6025 LAWNMOWER 190CC 550MM EN - Manual (Page 12)

POWXG6025
EN
Copyright © 2013 VARO P a g e | 12 www.varo.com
For best results your blade should be sharp. The blade may be resharpened by removing it
and either grinding or filing the cutting edge keeping as close to the original bevel as possible.
It is extremely important that each cutting edge receives an equal amount of grinding to
prevent an unbalanced blade. Improper blade balance will result in excessive vibration
causing eventual damage to the engine and mower. Be sure to carefully balance blade after
sharpening. The blade can be tested for balance by balancing it on a round shaft screwdriver.
Remove metal from the heavy side until it balances evenly.
Before reassembling the blade and the blade adapter to the unit, lubricate the engine
crankshaft and the inner surface of the blade adapter with light oil. Install the blade adapter on
the crankshaft with the "star" away from the engine. Place the blade with the part number
facing away from the adapter. Align the washer over the blade and insert the hex bolt. Tighten
the hex bolt to the torque listed below:
10.3 Blade mounting torque
Centre Bolt 40 Nm.min, 54 Nm.max. To insure safe operation of your unit. ALL nuts and bolts
must be checked periodically for correct tightness.
After prolonged use, especially in sandy soil conditions, the blade will become worn and lose
some of the original shape. Cutting efficiently will be reduced and the blade should be
replaced. Replace with an approved factory replacement blade only. Possible damage
resulting from blade unbalance condition is not the responsibility of the manufacturer.
11 STORAGE INSTRUCTIONS (OFF SEASON)
The following steps should be taken to prepare lawn mower for storage.
1.
Following the final cut of the season allow the fuel tank to run dry.
2. Clean and lubricate mower thoroughly as described in the lubrication instructions.
3. Lightly coat mower's cutting blade with chassis grease to prevent rusting.
4. Store mower in a dry, clean area.
NOTE:

When storing any type of power equipment in an unventilated or material storage shed, -
Care should be taken to rust-proof the equipment. Using a light oil or silicone, coat the
equipment, especially cables and all moving parts.

Be careful not to bend or kink cables.

If the starter rope becomes disconnected from rope guide on handle, disconnect and
ground the spark plug wire, Depress the blade control handle and pull the starter rope out
from engine slowly. Slip the starter rope into the rope guide bolt on handle.
12 TECHNICAL DATA
Power 4500W
Blade
Hex Bolt
Washer
Blade Adapter
Feather Key