Powerplus POWXG6025 LAWNMOWER 190CC 550MM EN - Manual (Page 8)

POWXG6025
EN
Copyright © 2013 VARO P a g e | 8 www.varo.com
WARNING: never fill fuel tank indoors, with engine running or until the
engine has been allowed to cool for at least 15 minutes after running.
 Fill fuel tank to base of tank filler neck. Use fresh, clean, regular unleaded gasoline.
 Do not overfill.
 Do not mix oil with gasoline.
 To assure fuel freshness, only purchase fuel in quantities that can be used within 30 days.
CAUTION: Wipe off any spilled oil or fuel. Do not store, spill or use gasoline
near an open flame
CAUTION: Alcohol blended fuels (called gasohol or using ethanol or
methan can attract moisture which leads to separation and formation of
acids during storage. Acidic gas can damage the fuel system of an engine
while in storage. To avoid engine problems, the fuel system should be
emptied before storage (See chapter Storage, further in this manual)
7.4 To start engine and engage blade
The unit is equipped with a rubber boot over the end of the spark plug, make certain the metal
loop on the end of the spark plug wire (inside the rubber boot) is fastened securely over the
metal tip of the spark plug.
7.4.1 Start (run)
 Before starting, push primer bulb, three times.
 Standing behind the unit, grasp the brake control handle and hold it against the upper
handle as shown.
 Grasp the starter handle as shown and pull up rapidly. Return it slowly to the rope guide
bolt after engine starts.
 To stop engine :
 Release the brake control handle to stop the engine and blade.
NOTE: Due to protective coatings on the engine, a small amount of smoke may be present
during the initial use of the product and should be considered normal.
7.5 Operation procedures
During operation, tightly hold the brake handle with both hands.
WARNING: During operation, when the brake handle is released, the engine
will stop and thus stopping the lawnmower from operating.
7.6 To stop engine
CAUTION: The blade continues to rotate for a few seconds after the engine
is shut off.
 Release the brake control handle to stop the engine and blade.
 Disconnect and ground the spark plug wire to prevent accidental starting while equipment
is unattended.
7.7 Connection for auto move