Powerplus POWXG3023 BRUSH CUTTER 51,7CC EN - Manual (Page 11)

POWXG3012+XG3023 EN
Copyright © 2012 VARO P a g e | 11 www.varo.com
12 TECHNICAL DATA
POWXG3012 POWXG3023
Engine type Air-cooled, 2 Cycle, Chrome cylinder
Engine displacement 32,6cc 51,7cc
Max spindle speed 8000 rpm 6500 rpm
Cutting width spool
Cutting disc
420mm
255mm
Knife 3 tanden
Handle “Bike” handle
Fuel tank capacity 1000 ml 1300 ml
13 NOISE
Noise values measured according to relevant standard. (K=3)
Acoustic pressure level LpA
91 dB(A)
Acoustic power level LwA 112 dB(A)
ATTENTION! The sound power level may exceed 85 dB(A), in this case
individual hearing protection shall be worn.
POWXG3012 POWXG3023
aw (Vibration) Max 9,9 m/s² 14,6 m/s² K = 1,5 m/s²
14 STORAGE
WARNING: Failure to follow these steps may cause varnish to form in the
carburettor and lead to difficult starting or permanent damage after storage.

Clean outside surface of unit.

Drain fuel from the fuel tank.

After fuel is drained, start engine.

Run engine at idle until unit stops. This will purge the carburettor of fuel.

Allow engine to cool (approx. 5 minutes).

Using a sparking plug wrench, remove the sparking plug.

Pour 1 teaspoon of clean 2-cycle oil into the combustion chamber. Pull starter rope slowly
several times to coat internal components. Replace sparking plug.

Store unit in a cool, dry place away from any source of ignition such as an oil burner, water
heater, etc.

Put the sleeve on when not in use or in transportation.
15 REMOVING A UNIT FROM STORAGE

Remove sparking plug.

Pull starter rope briskly to clear excess oil from combustion chamber.

Clean and gap sparking plug or install a new sparking plug with proper gap.(Fig. 24)

Prepare unit for operation.

Fill fuel tank with proper fuel / oil mixture. See Fuel and Lubrication Section.