Powerplus POWXG3023 BRUSH CUTTER 51,7CC EN - Manual (Page 6)

POWXG3012+XG3023 EN
Copyright © 2012 VARO P a g e | 6 www.varo.com
8 ASSEMBLY
8.1 Bike handle installation
Install the U-handle on the fixing holder, install the
clamp and fasten with the screws.
8.2 Installation protection guard
Turn the trimmer around and install the
protection guard as shown in the figure.
8.3 Installation of the cutting blade
CAUTION: NEVER use unit if blade is warped or has teeth that are chipped or
missing. Replace a damaged blade immediately.
CAUTION: Always wear heavy-duty work gloves when handling and installing
a blade.
Push the rear flange (b) onto the tool head,
followed by the cutting disc
(c) and the front flange (d).
Tighten down the entire mount with O - ring
(e) and nut (f).
At the same time, block the tool head by
means of a rod you can insert from the side
into the rear flange.
Use the cotter pin (g) to secure the blade
firmly in place.