Powerplus POWXG3023 BRUSH CUTTER 51,7CC EN - Manual (Page 8)

POWXG3012+XG3023 EN
Copyright © 2012 VARO P a g e | 8 www.varo.com
10 OPERATING INSTRUCTIONS
10.1 Harness
WARNING: ALWAYS WEAR SHOULDER HARNESS when operating unit with a
blade. Attach harness to trimmer after starting unit and engine is running at
IDLE. Turn ENGINE OFF before disconnecting shoulder harness.
Adjust length of shoulder strap so stringhead is parallel to the ground as it hangs from the
strap. A few practice swings without starting engine should be made to determine correct
balance.
NOTE: Detach the shoulder harness from the unit before starting engine.
10.2 Starting a cold engine

Move ignition switch to the “RUN (I)” position.

Push the primer bulb about 10 times.

Set throttle lock. Press the lock-off switch down and then, while holding trigger at wide
open position, press down and hold throttle lock. Release throttle trigger Throttle trigger will
now remain in the fully depressed position.

Move choke to the choke position.

Pull the starter rope about 10 times.

Move the choke to the middle position.

Pull the starter rope until the engine starts running.

Give the trimmer the time to run warm and put the choke in the ‘OFF’ position afterwards.
10.3 Starting a warm engine (engine has been stopped for no more than 15-20
minutes)

Move ignition switch to the “RUN (I)” position.

Set throttle lock.

Pull the starter rope until the engine starts running.
10.4 To stop the engine
To stop the trimmer, put the ignition switch in the ‘STOP’ position.
10.5 Trimming procedures
When properly equipped with a debris shield and stringhead, your unit will trim unsightly
weeds and tall grass in those hard-to-reach areas - along fences, walls, foundations and
around trees. It can also be used for scalping to remove vegetation down to the ground for
easier preparation of a garden or to clean out a particular area.
NOTE: Even if you are careful, trimming around foundations, brick or stone
walls, curves, etc., will result in above-normal string wear. To renew the wire,
press the lower spool knob against the ground with rotating trimmer.