Epson Equity 286 PLUS User Manual
Page 130
Align the connector with the socket so the tab on the
connector lines up with the notch in the socket. Make sure
the holes in the connector fit over all the pins in the socket
and then push in the connector.
Caution
If you do not correctly align the holes with the pins, you
could severely damage your computer when you push in
the connector.
7.
Now connect the hard disk drive cable in the same manner.
8.
To replace the front panel, fit the three ridged tabs on its
bottom edge into the three notches on the lower edge of the
computer, as shown below.
notches
tabs
9.
Tilt up the front panel until the clips on the top of the panel
touch the computer. Then push on the top of the panel
until it clicks into place.
10. Follow the steps on page 5-41 to replace the computer’s
cover. Then see “Post-installation Setup” on page 5-44 for
instructions on configuring your computer.
5-40
Installing and Removing Options