Epson Equity 286 PLUS - Manual (Page 56)

Caution
Do not reset the computer as a means to exit a program.
Some programs classify and store new data when you exit
them in the normal manner. If you reset the computer
without properly exiting a program, you may lose data.
To reset the computer, MS-DOS must be either on the hard disk
or on a diskette in drive A; so if you do not have a hard disk,
insert the Startup diskette in drive A.
There are two ways to reset the computer:
If you are using MSDOS, hold down Ctrl and Alt and press
the Del key. The screen goes blank for a moment and then
the computer should reload MS-DOS. If it doesn’t, try the
next method.
Press the RESET- button on the front panel. This method
works even when the computer does not respond to your
keyboard entries.
If resetting the computer does not correct the problem, you
probably need to turn it off and reboot it. Remove any
diskette(s) from the diskette drive(s). Turn off the computer and
wait five seconds. If you do not have a hard disk, insert the
Startup diskette in drive A. Then turn on the computer.
Using Your Computer 3-5