Epson Equity 286 PLUS - Manual (Page 171)

8. Use one of your hands to hold up the subassembly at an
angle or have someone hold it up for you. With your other
hand, reach back underneath the subassembly and
disconnect the two power supply cables connected to the
back right side of the main system board, as shown below.
Pull each of the connectors straight up. Do not pull only on
the cables.
9. Lift the entire subassembly out of the computer and carefully
place it on your work surface.
If you are installing a drive, follow the instructions under
“Installing a Disk Drive in the Horizontal Position” on the
next page.
If you are removing a drive, see “Removing a Disk Drive
From the Horizontal Position” on page B-43.
B-32 Installing
and Removing Disk Drives