Edelbrock Yamaha Rhino 660 - Manual (Page 3)

NOTE: Turn elbow until it is just below three
o’clock position as shown in picture above.
16. Install hose clamps on each end of
supplied 3/8 hose (blue). Lube the
inside of both ends of hose with a light
oil (WD-40 or similar). Push hose onto
oil fitting on engine and the opposite
end onto the factory hard tube coming
from the front of vehicle. See figures
10 and 11.
Figure 10.
Figure 11.
17. After each end of hose has been
installed tighten clamps.
18. Engage starter without opening
throttle. NOTE: The stock fuel pump is
vacuum operated, so it is
recommended that the starter be
engaged for at least 10 seconds.
19. After fuel has entered float bowl, pump
the throttle 3-5 times to prime the
accelerator pump.
20. Once pump is primed, start engine.
NOTE: The Edelbrock carburetor
does not have a choke system. Cold
starts will require 2-3 pumps of the
throttle pedal to activate the
accelerator pump.
For any questions regarding
tuning or installation of Edelbrock
products, please call our toll free
tech line M-F 8:00am-12: 30pm,
1:30pm-5:00pm PST.
877-888-7504 ext.2.
Edelbrock #3119 Yamaha
Rhino 660 Carburetor
Specifications
Bore Size: 40mm round
Needle: 18E @ 14 clicks
Accelerator Pump Bypass: 1.5
turns out.
Alternate Needles: 16E, 20E
Main Jet: 74
Alternate Jets: 72, 76
Replacement Throttle Cables:
#9353