Elmo Visual Presenter HV-5100XG - Manual (Page 19)

18
Simple steps for Presenting Printed Material
(1) Turn ON the power switch.
Before turning ON the power switch, connection to
the monitor should have been completed.
The indicator lamp (green LED) on the front panel
shows the initial status of each function.
If the power switch is turned ON immediately after
being turned OFF, this product may not operate.
For restarting, turn OFF this product and wait
several seconds then turn ON.
(2) Place the object on the stage. Adjust the image
size according to the object size using the zoom
buttons ([TELE] / [WIDE]) on the front
operation panel or the zoom tele/wide buttons
([ZOOM.TELE] / [ZOOM.WIDE]) on the
wireless remote control, while watching the
image on the TV monitor.
(3) Press the auto focus button [AF] on the front
panel or the wireless remote control.
The auto focus function works up to a height of
approx. 10cm (3.9 in) above the stage surface.
CON
ZOOM TELE WIDE AF
AF
NORMAL OPEN CLOSE
TELE ZOOM WIDE NEAR FOCUS FAR
6
OPERATION PROCEDURES
PAUSE
LAMP POSI/NEGA COLOR/B&W
IRIS
AF
2x
SET
RGB1 RGB2
NORMAL OPEN CLOSE
PRESET CALL
TELE ZOOM
MAIN MONITOR OUTPUT
WIDE NEAR FOCUS FAR
UPPER BASE
SET IMAGE CALL
Wireless remote control
CON
ZOOM TELE WIDE AF
IRIS
AF
NORMAL OPEN CLOSE
MONITOR OUTPUT PAUSE IRIS
CONTRAST POSI / NEGA
LAMP
WHITE
BALANCE
IMAGE
ROTATION
ZOOM
F.A.M.
MAIN
OPEN CLOSE
TELE WIDE
RGB1
RGB2
AF
AUTO/MANUAL
UPPER / BASE / OFF
(2) (3)
(2)
(3)
1
2
3
4
5
6
7
8
9
10
11
Front operation panel
Front operation panel
Front operation panel
Wireless remote control
Wireless remote control