Electrolux 316471400 - Manual (Page 44)

44
Self-Clean
Setting self-clean
The clean feature provides 3 different choices for
self-cleaning the upper oven. Set the clean for
lite
(2 hrs), med (3 hrs) or heavy soils (4 hrs). The
example below shows setting the upper oven for
self-clean to begin immediately using a medium (3
hour) setting.
or or
2. Choose LITE, MED OR
HEAVY CLEAN
1. Remove racks and
Press UPPER OVEN
3. Press START
Example
2. Choose LITE, MED OR
HEAVY CLEAN
1. Remove racks and
Press UPPER OVEN
5. Press START
Example
3. Press END TIME
4. Enter 800
Setting delayed self-clean
You may wish to set your appliance to perform a
self-clean cycle sometime later (up to 12 hours
later). The
END TIME key will determine when the
cleaning will stop.
You will need to set the END TIME out far enough
to allow for the type of clean cycle you choose (2-3-
4 hours). Remember to add 30-40 additional
minutes for the oven to cool enough and the oven
door to unlock.
The example below shows setting the upper oven
for a self-clean cycle to end at 8:00 o’clock.
After pressing start, the motorized oven door latch
will automatically lock the door. The DOOR lock
icon will flash (Fig. 1). Once the door has locked the
DOOR lock icon will remain on through the entire
self-clean cycle.
After self-clean, the oven may take about 30-40
minutes to cool and unlock. A
Hot message (Fig. 2)
will display during this period. After cooling the
DOOR lock icon will flash and disappear indicating
that the door has unlocked.
IMPORTANT
• A self-clean cycle will not start if the appliance
has the CONTROL LOCK turned on.
• If a self-clean cycle was started but did not
finish due to a power failure, your oven may
not be completely cleaned. After power has
been restored and the oven door has
unlocked, set for another self-clean if needed.
Example
Step Press
Step Press
Fig. 2 Fig. 1
Example
NOTES
• You may press CANCEL any time during the
cleaning process. After cancelling the self-
clean cycle, do not attempt to open the oven
door until the DOOR lock icon turns off.
• If you desire to set a delayed self-clean
cycle to end in 12-24 hours, use the USER
PREF key to set the 12hr energy saving mode
(ES) to OFF and also set the clock mode
(CLO) to 24 hr.
or or