Electrolux 316471400 - Manual (Page 51)

51
Removing and replacing the
warmer oven drawer
Care and Cleaning
Electrical Shock Hazard can occur and result in
serious injury or death. Disconnect appliance
from electric power before cleaning and servicing
the warmer oven.
To remove the warmer oven drawer:
1. Turn power
OFF before removing the warmer
oven drawer.
2. Open the warmer oven drawer completely.
3. On left warmer oven drawer rail, locate black
release lever and press up with finger while
pulling out slightly on the oven drawer handle.
On right warmer oven drawer rail, locate black
release lever and press down with finger while
pulling out slightly on the warmer oven drawer
handle -Fig. 1.
4. The warmer oven drawer should now be
released from the rails. Remove warmer oven
drawer (using level & square motion)
completely away from the appliance.
To replace the warmer oven drawer:
1. Pull the bearing glides to the front of the outer
compartment glide channels until they snap
into place -Fig. 3.
2. Carefully line up both sides of the warmer oven
drawer glide rails to the outer compartment
glide channels located inside the empty
warmer oven compartment -Fig. 2.
3. While holding the warmer oven drawer level
and square using the warmer oven drawer
handle, push (
DO NOT FORCE) the warmer
oven drawer all the way into the outer
compartment glide channels all the way into
the range. Pull the warmer oven drawer open
again to verify the glides have seated.
4. If you do not hear the levers “click” or the
bearing glides do not feel seated remove the
warmer oven drawer and repeat steps "1"
through "3". This will minimize possible
damage to the bearing glides.
Fig. 1
Left-hand rail and release
Right-hand rail and release
Warmer
oven
drawer
handle
Fig. 2
Left-hand channel
Right-hand channel
Fig. 3