Florabest FTS 1100 A1 - Manual (Page 38)

38
MT GB
Waste Disposal
and Environmental
Protection
Be environmentally friendly. Return the
tool, accessories and packaging to a recy-
cling centre when you have finished with
them. Hand the tool in at a recycling centre.
The plastics and metal parts can be sepa-
rated and recycled. Ask your Service Center
about this.
Do not dispose of electrical appli-
ances as unsorted municipal waste,
use separate collection facilities.
Contact you local government for
information regarding the collection
systems available.If electrical ap-
pliances are disposed of in landfills
or dumps, hazardous substances
can leak into the groundwater and
get into the food chain, damaging
your health and well-being. When
replacing old appliances with new
ones, the retailer is legally obligated
to take back your old appliance for
disposals at least free of charge.
Defective units returned to us will be dis-
posed of for free.
Faults - Causes - Remedies
Faults Causes Remedies
Pump does not start
Mains voltage is not applied Check mains voltage
Float switch (7) does not
switch
Bring float switch into higher
position
Pumps has no dis-
charge
Buckled pressure hose Repair point at which the line
is bent
Trapped air in the pump cas-
ing Tip the pump underwater until
the air escapes
Pump does not
switch off
Float switch (7) cannot drop
Set up pumps correctly on the
pit base
Flow rate insufficient
Reduces pump performance,
through severely contami-
nated water and additions in
the water which produce a
grinding effect Clean pumps and replace
wear parts
Pump switches off
after a short period
Motor contactor disconnects
the pumps because of water
pollution that is too severe. Pull out power plug and clean
the pump as well as shaft
Water temperature too high,
motor contactor breaks Note maximum water tem-
perature of 35°C!