Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4285-49 User Manual
Page 36
Preparing to Install the 4H4285-49
3-8 Installation
3.
Slide the module into the slot until you can engage the top and bottom locking levers
with the chassis as shown in
.
4.
Refer to the Caution note above, then rotate the two levers into the closed position.
5.
If the chassis in which the module is installed was powered down for the installation,
turn the power supplies on. Check to see that the module CPU LED settles at solid
green after a few minutes. If the LED does not turn solid green, refer to
for
troubleshooting details.
Caution: In step 4, do not force the locking levers to the point that they touch the face of
the front panel. Forcing the locking levers to this point could damage the module and
chassis.
Precaución: En el paso 4, tenga cuidado de no llevar las palancas de cierre a un punto
en donde estén en contacto con el panel frontal. Si lo hace, podría dañar el módulo o el
chasis.