Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4285-49 - Manual (Page 47)

Connecting to COM Port for Local Management
Matrix DFE-Gold Series PoE Module 4H4285-49 Installation Guide 3-19
4. Turn on the PC and configure your VT emulation package with the following
parameters:
5. When these parameters are set, the Local Management password screen will display.
Refer to the appropriate Enterasys Matrix DFE‐Gold Series Configuration Guide for
further information.
Connecting to a VT Series Terminal
To connect a VT Series terminal to an Enterasys Networks DFE module COM port
(
Figure 3‐10 ), use a UTP straight‐through cable with RJ45 connectors and an RJ45‐to‐DB25
female adapter, and proceed as follows:
Parameter Setting
Mode 7 Bit Control
Transmit Transmit=9600
Bits Parity 8 Bits, No Parity
Stop Bit 1 Stop Bit
Figure 3-9 Connecting an IBM PC or Compatible
1 UTP straight-through cable with RJ45 connectors 3 RJ45-to-DB9 PC adapter
2 RJ45 COM port 4 IBM PC or compatible device
1X
G
R
O
U
P
1
OFFLINE/
RESET
COM
CPU MGMT
GROUP
SELECT
GROUP
1
2
3
POE
1
2
3
4H4285-49
FAST ENET
Б
В Г А