Enterasys Networks Enterasys Gold Distributed Forwarding Engine 4H4285-49 - Manual (Page 79)

Gaining Access to Memory Modules
Matrix DFE-Gold Series PoE Module Hardware Installation Guide B-9
Installing the DRAM SIMM
To install the DRAM SIMM, refer to Figure B‐6 and proceed as follows:
1. With the connector arms set in the open position, insert the DRAM SIMM between the
connector fingers and push the DRAM SIMM into the connector until the tabs on the
two connector arms pull in towards the DRAM SIMM alignment notches.
2. Push the DRAM SIMM further into the connector until the two alignment notches and
the tabs on the two connector arms lock the DRAM SIMM into place.
3. Reinstall the NEM. Refer to “ Reinstalling the Optional Network Expansion Module ”
on page B‐12 for instructions.
4. Reinstall the safety cover. Refer to “ Reinstalling the Safety Cover ” on page B‐13 for
instructions.
Figure B-6 Installing the DRAM SIMM
Caution: Observe all Electrostatic Discharge (ESD) precautions when handling sensitive
electronic equipment.
Precaución: Al trabajar con equipos electrónicos sensibles, tome todas las precauciones
de seguridad para evitar descargas de electricidad estática.
1 Connector arms 3 Connector fingers
2 DRAM SIMM 4 Alignment notches (2)
В
А
А
Б
Г
Г