Charging the battery – Florabest FAT 18 B3 User Manual

Page 50

Advertising
background image

50

GB

Charging the battery

Do not expose the battery to

extreme conditions such as

heat or impact. Risk of injury

from escaping electrolytic so-

lution! After eye/skin contact,

rinse the affected areas with

water or a neutraliser and

consult a doctor.

Charge the battery in a dry room

only.

Prior to attaching the charger, check

that the battery‘s outer surface is

clean and dry.

There is a risk of injury due to elec-

tric shock.

Only use the original charger from

the package to charge the battery.

Mind not to charge the appliance

for more than 5 hours at a time. If

you do, the battery and the appli-

ance may be damaged and longer

charging times would be a waste

of energy. Excessive charging will

void the warranty.

Charge the battery before the first

time of use. Do not briefly charge

the battery several time in a row.

Recharge the battery when you no-

tice that the appliance is becoming

slower.

If a fully recharged battery lasts

for considerably shorter operating

times, the battery is used up and

needs to be replaced. Only use an

OEM spare battery available from

our Customer Service.

Always take heed of the applicable

safety instructions as well as the en-

vironmental protection regulations

and information.

The warranty excludes all defects

caused by improper handling.

Removing / inserting the

battery

1. To remove the battery (16) from

the appliance, press the release

button (17) on the battery and

pull out the battery.

2. To insert the battery (16), place

it on the guide track (20) and

push it back into the appliance.

It will audibly snap in.

Do not insert the battery until

the appliance is fully assem-

bled. Risk of injury!

Recharging the battery

Recharge the battery ( 16) when the

last charge state indicator LED ( 18)

lights up red.

One LED at the charging status indi-

cator ( 18) of the battery ( 16)

LED flashes green during the char-

ging process. A green LED for each

preloaded section of the batteries

( 16). If all three LED‘S of the indi-

cating charging status ( 18) lights

up green, the battery ( 16) is fully

charged.

1. Remove the battery (16) from the

appliance, as necessary.

2. Inser the battery (16) in the char-

ging compartment of the battery

charger (19). It will audibly snap

in.

3. Plug the battery charger (19)

into a mains outlet.

Advertising
This manual is related to the following products: