Florabest FAT 18 B3 - Manual (Page 51)

51
GB
on the motor head (10). If the
position is correct, the cross-head
screw on the pipe is no longer
visible.
4. To lock, turn the twist lock (24)
approx.45º clockwise. Lock closed
symbol .
To put on the protective
cover:
1. Place the protective cover (14) on
the motor head (10) and screw it
down with the 3 Phillips screws.
To put on the auxiliary
handle:
2. Pull the ends of the auxiliary
handle (5) to extend the handle
and slide it over the handle
holder (22). The storage box for
your plastic knife (4) must point
upwards.
3. Screw down the screw (23) in the
auxiliary handle (5).
Mounting the trimming unit:
4. Slip the cutting disc (12) onto the
axle. There is only one mount-
ing position. Screw the cutting
disc (12) to the axle. Mind the
left-hand thread. Please ensure
that the screws are properly tight-
ened.
Place the cutting insert (13) on
the pin (23) on the cutting disk
(12) and pull out the insert until it
snaps in.
Spare cutting inserts are kept in the
box (4) on the auxiliary handle (5).
4. When the battery is fully rechar-
ged unplug the battery charger
(19) from the mains.
5. Press the release button ( 17)
on the battery (16) and pull the
battery out of the battery char-
ger (19).
Used batteries
• If a fully recharged battery lasts for
considerably shorter operating times,
the battery is used up and needs to be
replaced. Only use an OEM battery
pack replacement available from our
Customer Service.
• Always take heed of the applicable
safety instructions as well as the envi-
ronmental protection regulations and
information (see “Cleaning and Main-
tenance”).
Assembling instructions
Do not insert the battery until
the appliance is fully assem-
bled. Risk of injury!
To put together the equip-
ment:
1. Turn the black twist lock (24) on
the motor head (10) until the
notches match up to those in the
green casing. Lock open symbol
.
2. When plugging in the telescopic
tube (9) be aware of the different
plastic pin thicknesses on the
tube. Only one position is possi-
ble.
3. Plug the end of the telescopic
tube (9) all the way into opening