Livarno Halogen Under-Cupboard Light - Manual (Page 7)

7 GB
Safety
Q Safety
Safety advice
The right to claim under the guarantee shall be
rendered invalid in respect of damage caused by
the non-observance of these operating instructions.
No liability is accepted for consequent damage.
No liability is accepted for damage to property
or persons caused by improper handling or non-
observance of the safety advice.
To avoid danger to life
from electric shock
J Before connecting the device to the mains
supply, always check the light, mains lead and
connection lead for damage. Never use your
light if you discover that it is damaged in any way.
CAUTION! A damaged mains lead or con-
nection lead presents a serious danger to life
from electric shock.
J Before assembly, ensure that the mains voltage
available corresponds to the operating voltage
necessary of the light (230 V~).
J Never let the lamp come into contact with
water or other liquids.
J Never open or insert anything into electrical
fittings or equipment. Doing this sort of thing can
lead to a serious danger to life from electric
shock.
J Touch only the insulated part of the plug when
connecting to or disconnecting from the mains
supply.
J If the external flexible cable of this lamp is
damaged, it may only be replaced by a special
cable or a cable that is only available from the
manufacturer or his service representative.
J Connect the under-unit light to the mains supply
using the original mains lead only.
J Connect this light only to other original under-
unit lights of the same type (Model 3005 / 034L
or 3005 / 036L). Use only the supplied origi-
nal connection lead to make this connection.
J Use only one mains socket for any series of
connected under-unit lights. Ensure that no more
than 3 under-unit lights of the same type are
connected together in series. Failure to observe
this advice could lead to overloading of the
connectors and leads.
J First ensure that all the under-unit lights are
connected by connection leads before you
insert the mains lead into the mains socket.
J Do not attach the light to damp or conductive
substrates.
To avoid danger of fire
and injury
J RISK OF INJURY! Check every bulb and
lampshade for damage immediately upon
unpacking. Do not operate the light with a
defective bulb or glass cover. If they are,
contact the service point for a replacement.
J RISK OF INJURY FROM BURNS! Ensure
the lamp has been switched off and allowed to
cool before you touch it. In this way you will
avoid the danger of burns. Light bulbs develop
a great deal of heat.
J Do not touch bulb components or bulbs as they
can reach temperatures > 350 °C during
operation.
J Allow the light to cool down completely before
replacing a defective bulb.
J Replace defective bulbs immediately. Before
replacing the bulb always remove the mains
plug from the socket.
J Do not operate this light with a dimmer or an
electronic switch. It is not suitable for this mode
of operation.
J
0.2 m
FIRE HAZARD! Fit the light so that
it is at least 0.2 m away from the
material illuminated. Fire can result
from the development of too much heat.
J Never leave the light operating unattended.
J Do not allow any objects to cover the light. Fire
can result from the development of too much heat.
J Do not allow the lamp or the packaging mate-
rials to lie around unattended. Plastic film or