Vi. boiler cleaning, Warning – Energy Tech Laboratories New Yorker CL Series User Manual

Page 34

Advertising
background image

34

VI. Boiler Cleaning

Figure 28: Cleaning of Boiler Flueways

A.

CLEAN THE FLUEWAYS (See Figure 28).

1. Disconnect oil line(s) and remove burner and burner

mounting plate. See Figures 1A thru 1D.

2. Lay protective cloth or plastic over combustion

chamber blanket.

3. Remove the smokepipe as necessary to gain access

to the boiler canopy.

4. Remove the jacket top panels.

5. Remove the canopy being careful not to damage the

cerafelt gasket.

6. Using a 1¼” diameter wire or fibre bristle brush

(30” handle) clean the flueways. Brush from the top
using diagonal strokes for best results. DO NOT
allow brush to strike the target wall or liner in the
chamber.

B.

CLEAN TOP OF BOILER SECTIONS.

1. Brush and vacuum the tops of the boiler sections.

C.

CLEAN THE FIREBOX.

1. Using wire or fibre bristle brush, clean crown

of boiler and inside of water legs. DO NOT
allow brush to strike target wall or blanket in the
combustion chamber.

D.

AFTER CLEANING, remove protective cloth with

debris and vacuum as necessary, but be careful not

to damage blanket. Inspect target wall, combustion
chamber blanket and burner mounting plate insulation

for signs of damage. If damaged, replace as needed.

E.

REASSEMBLE BOILER.

CAUTION:

Do not start the burner unless canopy,

smokepipe and burner swing door are secured in place.
1. Install the canopy taking care to align the gaskets

without blocking the flueways. If gasket is damaged,
replace as needed.

2. Close and secure burner swing door to front section

with fasteners.

3. Reconnect oil line(s).

4. Reinstall Top Panels and secure with sheet metal

screws.

5. Reinstall smokepipe on canopy and secure to collar

with sheet metal screws.

WARNING

All boiler cleaning must be completed with burner service switch turned off.

WARNING

The boiler must be connected to an approved
chimney in good condition. Serious property
damage could result if the boiler is connected
to a dirty or inadequate chimney. The interior of

the chimney flue must be inspected and cleaned
before the start of the heating season and
should be inspected periodically throughout the
heating season for any obstructions. A clean and

unobstructed chimney flue is necessary to allow
noxious fumes that could cause injury or loss
of life to vent safely and will contribute toward

maintaining the boiler's efficiency.

Advertising
This manual is related to the following products: