Livarno LLES B2 - Manual (Page 7)

LIVARNO LUX LLES B2
English - 5
Safety instructions
Before using this device for the first time, please read the following instructions carefully and take note of
the safety warnings, even if you are familiar with the use of electronic devices. Store these operating
instructions in a safe place for future reference. If you sell or pass on the device to someone else, be sure
to always include these operating instructions as they are an integral part of the device.
WARNING! This symbol indicates important information for safe operation of the
energy-saving outdoor spotlight and the safety of the user. Disregarding this
information can lead to material damage and/or health hazards and even death.
Fire hazard: Attach the energy-saving outdoor spotlight at a distance of at least
0.5m from illuminated materials. Excessive heat generation can cause a fire.
Any cracked protective cover must be replaced.
The energy-saving outdoor spotlight has an earth conductor. The earth conductor
(yellow/green) must be connected to the indicated terminal.
Electrical devices do not belong in the hands of children. Never allow children to use electrical
devices unsupervised. Children may not recognise potential risks. Always keep plastic packaging
away from children. It poses a suffocation risk.
If smoke is produced, or there are any unusual sounds or smells, turn the device off immediately.
In such cases, the device should not be used until it has been inspected by authorised service
personnel. Never inhale smoke from a potential device fire. If you have inhaled smoke, however,
consult a doctor. The inhalation of smoke can be harmful.
The housing of the energy-saving outdoor spotlight must not be damaged. There is a risk of an
electric shock if the housing is damaged.
Do not use the energy-saving outdoor spotlight in potentially explosive environments which
contain flammable gases, vapours or dust. It poses a risk of explosion.
Never open the housing of the energy-saving outdoor spotlight except to change the energy-
saving bulb. The circuit must be disconnected during all work on the energy-saving outdoor
spotlight, even when changing the light bulb! There is a risk of an electric shock if the housing is
open.