Livarno 4280-042L /4281-048L - Manual (Page 6)

7 GB
Start-up / Maintenance and Cleaning / Disposal / Information
Adjusting the height
Extending:
Press in the bushings 2 - 3 mm. Be careful not
to push the bushings all the way in.
Allow the counterweight 7 to slide up.
Shortening:
Lift the light whilst pulling the counterweight 7
down.
Shortening the ropes:
Loosen the socket head screws at the end of
the rope.
Adjust the rope to the desired maximum length.
Tighten the socket head screw.
Trim the excess rope.
Maintenance and Cleaning
CAUTION! RISK OF ELECTRIC SHOCK!
Disconnect the light from the mains circuit before
cleaning. To do so, remove the fuse or switch off
the circuit breaker in the fuse box (0 position).
Only use a dry, lint-free cloth for cleaning. Do
not use solvents, spirit or similar substances.
They could damage the light.
Allow the light to cool down all the way.
Disposal
The package and packaging materials
consist entirely of environmentally friendly
materials. They can be disposed of at
your local recycling facility.
The symbol of the wheelie bin with the
line through it means that, in the European
Union, the product has to be disposed
of in a separate refuse collection. This applies to
the product and to all components bearing this
symbol. Do not dispose of products bearing this
symbol in your normal household waste, but instead
they must be taken for recycling to a collection site
for electrical and electronic appliances. Recycling
helps to reduce the consumption of raw materials
and protects the environment.
Information
Warranty
You receive a 36 month warranty on this product,
valid from the date of purchase. The appliance has
been carefully produced under strict quality control.
Within the warranty period we shall rectify without
charge all material and manufacturing defects. In
the event of a defect arising during the warranty
period, please send the appliance to the listed Service
Centre address, making reference to the following
article number: 4280-042L / 4281-048L. Wear parts
(such as bulbs) and damage caused by improper
handling, non-observance of the operating instruc-
tions or unauthorised interference are excluded from
the warranty. The performance of services under the
warranty does not extend or renew the warranty
period.
Declaration of conformity
This product fulfils the requirements of the applicable
European and national directives (Electromagnetic
Compatibility 2004 / 108/EC, Low Voltage Directive
2006 / 95 / EC, Ecodesign Directive 2009 / 125 / EC,
RoHS Directive 2011 / 65 / EU). Conformity has
been demonstrated. The relevant declarations and
documents are held by the manufacturer.
Manufacturer / Service
Briloner Leuchten GmbH
Im Kissen 2,
59929 Brilon,
Germany
Tel.: +49 0 29 61 / 97 12–0
Fax: +49 0 29 61 / 97 12–199
E-Mail: [email protected]
www.briloner.de
Safety / Start-up