Silvercrest SEM 1100 A2 - Manual (Page 17)

15 SEM 1100 A2
GB
Cleaning and Care
WARNING - RISK OF INJURY!
Always remove the plug from the mains power socket before you clean the ■
appliance. Risk of electric shock!
Always allow the appliance to cool down before you start to clean it. Risk of ■
Burns!
NEVER submerse the appliance in water or other liquids. Risk of electric ■
shock!
Cleaning the milk frother
ATTENTION - PROPERTY DAMAGE
NEVER use abrasive, corrosive or chemical agents to clean the appliance. ■
These could damage the upper surfaces of the appliance.
Place an empty container under the milk frother 1) z.
Immediately after use turn the steam control knob 2) 2 to the position “+ “ and,
for a few seconds, allow the steam to escape.
Turn the steam control knob 3) 2 off (as far as it will go in the direction “-”),
switch the appliance off and remove the plug from the mains power socket.
Allow the nozzle to cool down. 4)
Remove the nozzle and clean it thoroughly in warm water. 5)
Check to see if the small hole in the nozzle is clogged and, if so, clear it with 6)
a needle.
Clean the steam delivery tube of the milk frother 7) z with a damp cloth.
Replace the nozzle back onto the steam supply pipe. 8)
Cleaning the hot water shower
Clean the hot water shower t after each use:
After you have prepared the espresso/cappuccino and removed the sieve 1)
holder w, wipe the entire surface of the hot water shower t with a moist
cloth so that all powder residues are removed.
Then place an empty cup under the hot water shower 2) t and turn the function
rotary knob 5 to the position „ “. Water fl ows from the hot water shower
t and it fl ushes the last remaining powder residues out. With this, the water
can spray a little.
After about 20 seconds place the function rotary knob 3) 5 back to the position
„ “ and switch the appliance off with the On/Off switch 3.