Silvercrest SWW 1500 A1 - Manual (Page 13)

11
Assembly/Handling and operation
SWW 1500 A1
GB
Remove the device from the wall again. With an electric drill and an 8 mm ♦
drill bit drill the hole to a depth of, at least, 40 mm, subsequently insert the
rawlplug into the hole.
Hang the device on the wall and tighten the screw with the angle bracket ♦ D
(see diagram Tightening the angle bracket).
OW R
+
Diagram Tightening the angle bracket
Insert the power plug into a mains wall socket. ♦
Handling and operation
NOTICE
All functions can be switched both with the buttons on the device and with ►
the remote control.
In this section you receive important information for the handling and operation
of the device.
Switching the device on and off
With the main switch POWER 6 the device is completely disconnected from the
mains power.
Firstly switch the main switch POWER ♦ 6 on and/or lastly off when you are
no longer operating the device.
Heating operation
Activate the main switch POWER ♦ 6 to switch the device on. In the display
appears briefl y and subsequently the current device temperature in the
area of the integrated temperature sensor. The device is now in standby
mode. In the display
the symbol for the frost protection function blinks.
Press the button POWER/MODE ♦ 3 and/or 12 . The device switches on
with the low heat output (LOW). In the display appears .
Press the button POWER/MODE ♦ 3 and/or 12 again to set the high heat
output (HIGH). In the display appears .
D