Silvercrest SWW 1500 A1 - Manual (Page 15)

13
Handling and operation
SWW 1500 A1
GB
Whilst the preset time is blinking in the display ♦ press one of the buttons
+/- 4 and/or 13 to set the desired switch on time between 1 hour and 24
hours. As soon as the switch on time lights up continuously in the display
the setting is adopted and the device switches on, after the time has expired,
to the high heating output (HIGH).
Press the button AUTO ON ♦ 2 and/or 11 again if you want to deactivate
the switch on time. In the display the indicator AUTO ON goes out.
Overheating protection
With excessive temperature rise the device automatically switches off and in the
display
appears .
Should this occur...
Switch the device off at the main switch POWER ♦ 6 and pull the mains power
plug from the wall socket. Allow the device to cool down for a few minutes
After the cause of the overheating has been removed, i.e. a covered heating ♦
element, the device can be switched on again.
Frost protection function
The device is equipped with a frost protection function which automatically switches
to the high heat output (HIGH) as soon as the room temperature falls below 7°C.
When the room temperature has reached 10°C the appliance automatically
switches back to standby mode.
Activate the main switch POWER ♦ 6 to switch the device on and to shift
into standby operation. In the display the symbol for the frost protection
function blinks.
The device now switches on if the room temperature drops below 7°C.
Topple over protection
The device is equipped with topple over protection which automatically switches
the heating element
9 off if the device topples over. In addition a warning tone
sounds for 1 minute.