Epson 8150i - Manual (Page 48)

Displaying and Adjusting the Image 43
Using the Projector’s Feet
If the image is still too low, you can raise it by extending the
projector’s feet.
1. Stand behind the projector. Pull up the blue foot release levers
and lift the front of the projector. This unlocks the feet.
2. Once the image is positioned where you want it, release the levers
to lock the feet in position.
3. To fine-tune the height of the image, rotate the thumb wheels
attached to the projector’s feet.
If the image is no longer square after raising it, see the next section.
Adjusting the Image Shape
If the projected image isn’t square or has a “keystone” shape, do one or
more of the following:
■ If your image looks like or , you’ve placed the
projector off to one side of the screen, at an angle. Move it directly
in front of the center of the screen, facing the screen squarely.
■ If your image looks like or , press the + or – side of the
Keystone button to correct the shape of the image. After
correction, your image will be slightly smaller.
caution
Do not hold the projector by
the lens; this can damage it.
Keystone