Epson 8150i - Manual (Page 52)

Displaying and Adjusting the Image 47
Shutting Down the Projector
When done using the projector, turn off the projection lamp. If the
projector is connected to your network, leave it plugged in so that it
can continue to receive data over the network. If you need to unplug
the projector, as when moving it, be sure to turn off the projection
lamp (if it’s on) and let the projector cool before unplugging it.
Follow these steps to turn off the projection lamp:
1. Press the red Power button on the projector or remote control.
You see a confirmation message. (If you don’t want to turn it off,
press any other button.)
2. Press the Power button again. The power light flashes orange for
about a minute as the projector cools down. Once the projector
has finished cooling, the orange light stays on and the exhaust fan
shuts off. This means the projector is in “sleep mode,” but it can
still receive data over the network.
3. If necessary, unplug the power cord. (When unplugged, the
projector won’t be accessible to users over the network.)
note
When the projector has not
received any input signals for
30 minutes, it automatically
turns off the projection lamp
and enters “sleep mode.” This
conserves electricity, cools the
projector, and extends the life
of the lamp.
power light
power button
caution
To avoid damaging the
projector or lamp, never
unplug the power cord when
the power light is green or
flashing orange.