Electrolux E30DF74EPS - Manual (Page 21)

21
Installation
Connecting the Green Appliance Wire to a Grounded Supply Wire
or a Grounded Cold Water Pipe – Where Local Codes Permit.
1 Separate the green and white appliance wires.
2 Connect the white appliance wire to the neutral (white) supply wire in the
junction box.
3 Connect the black appliance wire to the black (L1) power supply wire in the
junction box.
4 Connect the red appliance wire to the red (L2) power supply wire in the
junction box.
5 Connect the green appliance wire to a grounded supply wire in the junction
box or to a grounded cold water pipe.
6 If connecting to a grounded cold water pipe, a separate copper grounding
wire (No. 10 minimum) must be connected to a grounded cold water pipe
by means of a clamp and then to an external grounding connector screw.
WARNING WARNING WARNING WARNING WARNING
• Do not ground the appliance to a gas supply pipe or hot water pipe.
• Do not turn on power to the appliance until the range is permanently grounded.
• A grounded cold water pipe must have metal continuity to electrical ground and
must not be interrupted by insulating materials. Any insulating materials must be
jumped with a length of No. 4 copper wire securely clamped to bare metal at both
ends.
Figure 16
Connecting the appliance ground to a grounded junction box wire
or grounded cold water pipe
Conduit from
appliance
Cable from
power supply
Wire nut
(4 places)
Junction
box
RED
RED
GREEN
GREEN
WHITE
WHITE
BLACK
BLACK
Separate No. 10 (minimum)
copper grounding wire
Clamp must be
tight on pipe
No. 4
copper wire
Metal
water pipe
Clamps
Bare metal
Meter