Electrolux E30DF74EPS - Manual (Page 23)

23
Installation
INSTALLING THE RANGE
Measure from the floor to the countertop and adjust the leveling legs as required to
position the top frame at the desired height, based on the cabinet and countertop
installation. Carefully slide the range into position in the cutout. The rear anti-tip leg
should engage the anti-tip bracket.
INSTALLING THE BURNER COMPONENTS
Remove the brass burner rings, porcelain burner caps, and porcelain gates from
their shipping packages. Place each burner ring onto its corresponding burner
base, being certain that the four alignment tabs slide into the matching notches in
the base. Set each porcelain burner cap on top of its corresponding burner ring.
Place each grate onto the top frame, being certain that the rubber feet are
positioned in the locating dimples.
WARNING WARNING WARNING WARNING WARNING
Never attempt to operate the cooktop section of the range with any of the burner rings,
burner caps or grates removed.
NO NO NO NO NOTE TE TE TE TE
Prior to operating the cooktop or oven sections of the range, please read the
accompanying Use and Care Manual carefully. Important safety, service and warranty
information is contained within this manual.