Electrolux E30DF74EPS - Manual (Page 7)

7
Preparing for Installation
VERIFY PACKAGE CONTENTS
• Use & Care Manual • Burner Rings
• Broiler Pan/Insert • Wok Ring
• Anti-tip Bracket • Simmerplate
• Grate Pack • Stainless Steel Cleaner
• Griddle • Roasting Rack
• LP Conversion Kit • Burner Cap Pack
GAS SUPPLY REQUIREMENTS
Check your local building codes for the proper method of installation. In the
absence of local codes, this appliance should be installed in accordance with the
National Fuel Gas Code ANSI Z223.1. Be certain that the appliance being installed
is correct for the gas service being provided. Refer to the rating label located on the
kick panel and/or the table below for gas supply requirements.
GAS AND ELECTRIC REQUIREMENTS TABLE
Refer to the following table for more information on gas and electric requirements.
Model No. Electrical
circuit
required
Total
connected
load
Gas type Manifold
pressure
Minimum gas
supply
pressure
E30DF74EPS
240-4
Wire VAC,
60Hz, 30A
26.4 Amps
(6.3 Kw)
Natural
Natural
Natural
4” Water Column
4” Water Column
4” Water Column
5” Water Column
5” Water Column
5” Water Column
E48DF76EPS
E36DF76EPS
240-4
Wire VAC,
60Hz, 30A
240-4
Wire VAC,
60Hz, 50A
26.4 Amps
(6.3 Kw)
44.2 Amps
(10.4 Kw)
Liquid Propane 10” Water Column 11” Water Column
Liquid Propane 10” Water Column 11” Water Column
Liquid Propane 10” Water Column 11” Water Column
NO NO NO NO NOTE TE TE TE TE
This range is shipped from the factory pre-set for use with natural gas. For LP
conversion see the accompanying LP Conversion Kit. The electrical information in the
table is also located on the serial number label on the range. It can be found by
opening the oven door and looking through the inlet air cooling grill.