Qlima A25 - Manual (Page 44)

44
4
BATTERY REPLACEMENT OF THE REMOTE CONTROL
If the batteries of the remote control need to be replaced, remove the cover of the backside
of the remote control, as shown in picture 5. Replace the old batteries by the new ones.
Respect the + and - poles. Don’t use any other batteries than CR2032 lithium 3V.
DESCRIPTION OF THE DISPLAY
1 4 2 5 3 6 7
Picture 7
1. Shows the set ventilator capacity. The ventilator capacity can be set by pressing But-
ton 2 (Figure 3) or Button 4 on the remote control (Figure 4). By pressing this button
repeatedly the capacity of the ventilator will cycle from LOW to MEDIUM to HIGH and
back to LOW again.
2. SLEEP MODE; can only be set using the remote control by pressing Button 5. The ven-
tilator will switch to a low capacity so that the air cleaner becomes whisper quiet.
3. Indicates that the air cleaner is switched on. The air cleaner can be switched on and off
by pressing button 1 on the display or the remote control.
4. Remote control receiver
5.
AUTO: indicates that the air cleaner is in AUTO MODE. The air cleaner can be switched
on and off by pressing button 3 either on the display or on the remote control.
The air cleaner will operate in a loop-cycle and start at HIGH fan speed for 2 hours,
followed 2 hours at MEDIUM fan speed and 2 hours at LOW speed. After this cycle
the unit will start at HIGH speed for two hours again.
HIGH
speed
2 hours
MEDIUM
speed
2 hours
LOW
speed
2 hours
REMARK:
To operate the unit in auto mode, the air cleaner must be switched on by
pressing button 1 (On/Off button).
G
6. Indicates that the air cleaner is in child lock mode. When the air cleaner is in child lock
mode the settings cannot be changed. The child lock can only be turned on or off by
pressing Button 2 on the remote control.
7. Indicates that the timer function is switched on. The air cleaner will automatically be
switched off when the time set has elapsed. The timer function can be set by press-
ing button4 on the display or Button 6 on the remote control. By repeatedly pressing
Button 4 the time to be set will cycle from 1 hour to 4 hours and then to 8 hours. By
pressing Button 4 again the timer function will be switched off again.
44