Qlima A25 - Manual (Page 46)

46
4
7. Reset the filter alarm by pressing Button 3 and holding it depressed for 3 seconds
until Light 3 stops flashing.
8. The air cleaner is now ready for use again.
9. Used filters can be disposed of in the regular house hold garbage with a problem.
G
If Light 3 is flashing then the filter package must be replaced. The filter alarm
can be reset by pressing Button 2 for about 3 seconds.
G
ATTENTION!
• Always replace dirty filters with new filters. Never re-use a dirty filter, even after
it has been cleaned.
• Depending on the circumstances it might be comfortable to replace the filters
more frequent.
CLEANING THE PRE-FILTER
The pre-filter must be checked weekly for dirt and if necessary be cleaned.
1. Unplug the device from the wall socket.
2. Remove the front panel (See chapter on Installation)
3. Remove the pre-filter. It can be easily separated from the filter package.
4. Clean the pre-filter with a vacuum cleaner, brush or a soft, damp cloth.
5. If it is badly fouled then the filter can be rinsed in lukewarm water.
6. Replace the pre-filter on the filter package and replace the front panel.
7. The air cleaner is now ready for use again.
CLEANING
Switch off the air purifier and remove the plug from the socket before cleaning.
THE EXTERIOR
Clean the exterior with a soft, dry cloth.
If the device is extremely dirty, use a mild cleaning agent.
Wipe the device with a slightly damp cloth.
Never spray the device with water.
STORAGE
If the machine will not be used for a long period of time, take the following steps:
1. Switch off the device.
2. Remove the plug from the socket.
3. Clean the machine.
4. Remove the filter package. Remove the batteries from the remote control.
6. Store the device in a dust free room, preferably covered.
46