RISCO Group GT480 - Manual (Page 11)

P P P P a a a a g g g g e e e e 9 9 9 9
If Anti has been programmed for Alarm Reset, contact the Central
Station or Engineer, (as instructed by the Installation Company) and
quote the number given by the display.
1) The central station or engineer will give a return
Anti-Code, (this may contain the YES ( ) & NO ( ) keys
for example: 5, YES ( ), 2, 4.
2) Enter this Anti-Code into the keypad.
The system is now reset.
Tamper Reset
If a fault or tamper occurs when the system is in Day (Unset) mode, the
fault sounder will operate. The display will
show:-
1) To view the cause of the fault, enter
your User Code.The display will
show, for example:-
2) The message will stay on the
display for 10 seconds or until you
press the 0 key. The display will
then return to:-
After the cause of the fault has been recti-
fied, the system will need to be reset.
The terms of your insurance may prohibit User reset. If Tamper
Reset has been programmed for Engineer Reset the display will
show for 10 seconds each time the user
attempts to set the system. Please contact your installation
company.
! ! ! ! CHECK ! ! ! ! !
! ! ! ! CHECK ! ! ! ! !
Tamper
! ! ! ! CHECK ! ! ! ! !
! ! SERVICE DUE !
GardTec 480 User PR5831_11 5IN480UM_B A6 booklet.qxd 19/07/2007 17:18 Page 9