Rose Electronics UltraView Remote 2 - Manual (Page 10)

INSTALLATION
6 ULTRAVIEW REMOTE 2 INSTALLATION AND OPERATIONS MANUAL
UltraView Remote 2 Installation
Installing the UltraView Remote 2 is a very easy process and should be performed by a designated administrator.
The administrator will install, configure, and set-up user access profiles. A network administrator will need to assign
an IP address to the unit (if needed) and set-up firewall and network access to the unit.
The following installation procedure is a guide to properly install and configure the UltraView Remote 2. The
following items are needed to install the UltraView Remote 2:
1. A valid IP address to assign to the unit (if not using DHCP feature)
2. VGA monitor
3. PS/2 keyboard
4. PS/2 mouse
5. RJ45 network cable
6. KVM Adapter cable (DB25M to PS/2F-PS/2F-HD15F)
7. CPU Adapter cable(s) (DB25M to PS/2M-PS/2M-HD15M)
Connecting the KVM station
Connect the KVM stations PS/2 keyboard, video monitor and PS/2 mouse cables to the corresponding connectors on
the KVM adapter cable as shown in Figure 2. The KVM station’s video monitor should be equal or better than any of
the connected computers. Connect the DB25M end of the KVM cable to the KVM DB25F port on the rear panel of
the UltraView Remote 2 unit.
Figure 2. Connecting a KVM
KVM Adapter Cable
KVM Station