TA Triumph-Adler CX 8048 - Manual (Page 21)

1. 7. 3 Treatment against environmental condition
Take a necessary treatment according to the environmental condition as shown below.
Humidity(%) Possible problem Necessary treatment
“Void of image”, “crease of paper” and
other problems occurs when you print
with plain paper and tracing paper.
1. Install the humidifier in the room, and
humidify the room air.
2. Remove the paper from the machine
right after the completion of print, and
keep it in a polyethylene bag.
“Void of image” occurs when you print
with tracing paper.
If you will not make print soon, remove
the tracing paper from the machine and
keep it in a polyethylene bag.
Remove the paper from the machine after
everyday use, and keep it in a
polyethylene bag.
“Void of image” occurs when you print
with plain paper and tracing paper.
If you will not make print soon, remove
the tracing paper from the machine and
keep it in a polyethylene bag.
Low
40%
70%
High
“Void of image”, “crease of paper” and
other problems occurs when you print
with plain paper and tracing paper. 1. Turn on the Dehumidify Heater.(if
installed)
2. Remove the paper from the machine
right after the completion of print, and
keep it in a polyethylene bag.
If the media is humidified:
If the media is humidified:
Crease of paper
Loss of image Normal Print
Normal Print
NOTE
(1)
CX 8048 is equipped with the Dehumidify Heater (optional for the US).
Using it in high humidity environment (65% or higher) is recommended.
Refer to [2. 9 Dehumidifying Roll Media] on page 2-18.
(2) “Void of image” and “crease of paper” will occur in case of extremely high or low
humidity.
Chapter 1 Before Use 1-15