TA Triumph-Adler 3555i - Manual (Page 458)

10-20
Troubleshooting > Troubleshooting
2 or more sheets are
overlaps when ejected.
(multi feed) ― Load the paper correctly. page 3-18
page 3-26
Printouts are wrinkled. Are the originals loaded correctly? Load the paper correctly. page 3-18
page 3-26
― Clean the paper separator. page 10-5
― Turn the orientation 180 degrees around
in which the paper is positioned. page xiv
page 3-18
page 3-26
Is the paper damp? Replace the paper with new paper. page 3-16
Printouts are curled. ― Turn the paper over in the cassette, or
turn the orientation 180 degrees around
in which the paper is positioned. page xiv
page 3-18
page 3-26
Is the paper damp? Replace the paper with new paper. page 3-16
Is the paper printed out to the finisher? Change the [Correct Paper Curl]. page 8-59
― Check the specified cassette and
change its paper type to Custom 8.
NOTE
If you specify the paper type to Custom
8, copy speed or printing speed
becomes slower.
page 3-30
Cannot print. Is the machine plugged in? Plug the power cord into an AC outlet. ―
Is the machine powered on? Turn on the main power switch. page 2-10
Are the printer cable and network cable
connected? Connect the correct printer cable and
network cable securely. page 2-6
Was the machine powered on before the
printer cable was connected? Power on the machine after connecting
the printer cable. ―
Is the print job paused? Resume printing. page 7-4
Cannot print with USB
memory.
USB memory not
recognized. Is the USB host blocked? Select [Unblock] in the USB host
settings. page 8-50
― Check that the USB memory is securely
plugged into the machine. ―
Printouts have vertical lines. Are the slit glass and the Dual scanning
area dirty? Clean the slit glass and the Dual
scanning area. page 10-3
Symptom Checkpoints Corrective Actions
Reference
Page